OKI ML3390 01091308*01256402 User Manual
Product codes
01091308*01256402
Chapter 14: Epson - Standard Functions
14-15
Page formatting
Function
Dec.
Hex.
ASCII
Page length in lines
27 67 n
1B 43 n
ESC C n
n = 1 to 127
Page length in inches
27 67 0 n
1B 43 00 n
ESC C NUL n
n = 1 to 22
By selecting page length you can inform the printer of the size of the
paper used. When is switched on the current position of the print
head is registered as Top of Form, i.e. first print line on the page.
When printing forms it is important that the page length is set to the
dimensions of the form so that not only the first but also all follo-
wing form sets are printed in the right position.
paper used. When is switched on the current position of the print
head is registered as Top of Form, i.e. first print line on the page.
When printing forms it is important that the page length is set to the
dimensions of the form so that not only the first but also all follo-
wing form sets are printed in the right position.
Normally a standard length can be set in the Page Length menu
item, though the page length can also be defined by one of the abo-
ve commands in inches or in the number of lines. For the latter it
must nor exceed 50 inches. Otherwise the command will be igno-
red.
item, though the page length can also be defined by one of the abo-
ve commands in inches or in the number of lines. For the latter it
must nor exceed 50 inches. Otherwise the command will be igno-
red.
If Page Length Control is by MENU Setting, the start position for
the sheet is not reset. Defining the page length in lines is done as a
function of the current line spacing. However, any subsequent
change of line spacing does not change the page length. When
using these two commands to change the page length the form start
position is reset, a »Skip over Perforation« defined by command is
deactivated and the value for the skip over perforation selected in
the menu item is used. Set vertical tabs are deleted.
the sheet is not reset. Defining the page length in lines is done as a
function of the current line spacing. However, any subsequent
change of line spacing does not change the page length. When
using these two commands to change the page length the form start
position is reset, a »Skip over Perforation« defined by command is
deactivated and the value for the skip over perforation selected in
the menu item is used. Set vertical tabs are deleted.
Function
Dec.
Hex.
ASCII
Activate Skip over
27 78 n
1B 4E n
ESC N n
Perforation
n = 1 to 127
Deactivate Skip over
27 79
1B 4F
ESC O
Perforation
With this function the lower area of a page can be skipped automa-
tically.
tically.
Set page length
Skip over
Perforation
Perforation