OKI ML3390 01091308*01256402 User Manual

Chapter 4: Printer menu settings

4-10

Rear Feed,
Bottom Feed

Top Feed

Select between 6 lpi (lines per inch, corresponds to

1/6 inch line spacing) or 8 lpi (corresponds to 1/8 inch line spac-
ing).

 If this function is activated, continuous paper is

automatically transported to the tear-off position after the time pre-
set in the menu (500 ms, 1 sec, 2 sec). The OFF setting switches the
Form Tear-Off function off. Further information on this function is
to be found in the chapter »Paper Handling«.

 Select Yes if you wish continuous paper to

be automatically transported to the top of the next page 2.54 centi-
metres (1 inch) before it reaches the bottom edge of the page. If page
formatting is performed by the software, set this item to No in order
to avoid problems.

This menu item is only offered with wide printer mod-

els. Select the page width for the paper you are using. The standard
setting is 13.6 inch.

 Select here the page length for the paper you are

using to ensure the initial printing position is the same for each
page.

 select between 6 lpi (lines per inch, corresponds to

1/6 inch line spacing) or 8 lpi (corresponds to 1/8 inch line spac-
ing).

When Valid is set, a bottom margin of one inch

(2.54 cm) is always left unprinted when feeding cut sheets via the
paper support or when using an automatic cut sheet feeder.

This menu item is only offered with wide printer mod-

els. Select the page width for the paper you are using. The standard
setting is 13.6 inch.

 Select here the page length for the paper you are us-

ing to ensure the initial printing position is the same for each page.
The page length set here is only used if the value By MENU Setting
has been selected in the menu item Page Length Control.

Where cut sheets are being fed from above via the pa-

per support, the sheets are automatically drawn after the preset
time.