Smart Communications Ltd SC980A User Manual
Page 5/12
SUPPLIED ACCESSORIES
The following accessories
Microphone (with cable)
………………………1
Microphone hanger
………………………1
DC power cable (with Fuse)
………………………1 (15A Fuse X2)
Mounting bracket (with screw)
………………………1 (screw set)
Instruction manual ………………………1
PREPARATION
POWER CABLE CONNECTION
CAUTION
The transceiver operates in 12 V negative ground systems only! Check the battery polarity
and voltage of the vehicle before installing the transceiver.
Do not cut and/or remove the fuse holder on the DC power cable.
1. Check for an existing hole, conveniently located in the firewall, where the power cable
can be passed through. If no hole exists, use a circle cutter to drill the firewall, then
install a rubber grommet.
2. Run the two power cable leads through the firewall and into the engine compartment,
from the passenger compartment.
3. Connect the red lead to the positive (+) battery terminal and the black lead to the
negative (-) battery terminal.
・Locate the fuse as close to the battery as possible.
4. Coil and secure the surplus cable with a retaining band.
・Be sure to leave enough slack in the cables so the transceiver can be removed for
servicing while keeping the power applied.