ChipSiP Technology Co. Ltd. CWFB11X-XXX User Manual

You are cautioned that changes or modifications not expressly approved by the part 

responsible for compliance could void the user’s authority to operate the equipment. 

This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to part 15 of the FCC rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential installation. 

This equipment generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the 

following measures: 

-Reorient or relocate the receiving antenna. 

-Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

1) this device may not cause harmful interference, and 

2) this device must accept any interference received, including interference that may 

cause undesired operation of the device. 

 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. This equipment should be installed and operated with minimum distance 20cm 

between the radiator & your body. This transmitter must not be co-located or operating in 

conjunction with any other antenna or transmitter. 

The following statement must be included with all versions of this document supplied to an OEM or 

integrator, but should not be distributed to the end user. This device is intended for OEM integrators 

only. Please see the full Grant of Equipment document for other restrictions. This device must be 

operated and used with a locally approved access point. 

The final end product must be labeled in a visible area with the following:   

“Contains FCC ID: O7N-CWFB1XX-XXX”.