NET POWER Co. Ltd. NPU-10 User Manual
5.
Solving the Problems
▣ e-CAM does not setup in a correct way.
(See this manual)
Remove incorrect setup program, and then set it up again.
Remove incorrect setup program, and then set it up again.
▣ Light of LED in front of e-CAM does not turn on.
Make sure the cable is connected.
▣ Picture on the screen is not clear.
Adjust the camera focus. You can adjust by rotating the hood of the lens to right or left. Also
make sure, some other materials are stained to lens. If other materials are stained to lens, you
can clean by using alcohol.
make sure, some other materials are stained to lens. If other materials are stained to lens, you
can clean by using alcohol.
▣ Picture is too bright or too dark.
Brightness of picture is automatically adjusted, but in the case when the camera is located in
back-light or dark indoor, it must adjust the brightness by hand. See video property of the
manual.
back-light or dark indoor, it must adjust the brightness by hand. See video property of the
manual.
▣ Color of picture is thick or thin.
You can adjust the color by changing the switcher's value at the "Video Proc Amp" of the
video property.
video property.