Inovonics Wireless Corporation 3B6AVBST User Manual
4
QSR Performance Solutions Drive Thru - Belt-Pack
1 2 3 4 5 6 7 8
9 10 11
Bottom View
7. Talk 2
•
Has the exact same function as Talk 1 when used with a single lane
system
system
•
On Dual and Cross Lane systems Talk 2 will be programmed to
communicate with Lane 2
communicate with Lane 2
8. Talk 1
•
Activates communication to outside speaker
•
Will also be heard by other headsets and possibly grill speaker
(depending on system configuration)
(depending on system configuration)
•
Can be used to test incoming and outgoing audio even when no car
is present
is present
•
On half-duplex systems, press to talk and release to listen
•
On full-duplex systems incoming audio will be heard even while Talk
1 is pressed
1 is pressed
•
On Dual and Cross Lane systems Talk 1 will be programmed to
communicate with Lane 1
communicate with Lane 1
9. Headset Jack
•
The 2 prong headset connector plugs in here
10. Battery Compartment
•
Battery goes here
11. Battery Release
•
Slide back to release battery from compartment
1. Page
•
Press to talk to the other headsets without being heard at the
speaker post
speaker post
•
Belt-packs can be programmed for Page Monitor Mode, they will
only hear communication from other belt-packs that are using the
Page button and will not hear communication to or from the speaker
post
only hear communication from other belt-packs that are using the
Page button and will not hear communication to or from the speaker
post
•
To program a belt-pack for Page Monitor Mode, hold Page button
down while powering the headset on.
down while powering the headset on.
•
To exit Page Monitor Mode turn the belt-pack off and back on
2. Volume Down
•
Listening volume can be adjusted in 7 steps from the lowest to high-
est setting. When the belt-pack is powered on, the listening level will
be near mid-level and can be adjusted 3 steps up or 4 steps down.
A short tone will be heard each time the volume is adjusted. A long
tone is heard when the lowest or highest level is reached.
est setting. When the belt-pack is powered on, the listening level will
be near mid-level and can be adjusted 3 steps up or 4 steps down.
A short tone will be heard each time the volume is adjusted. A long
tone is heard when the lowest or highest level is reached.
3. Volume Up
•
Turns up incoming audio from speaker post. See previous section
for details
for details
4. Power LED
•
Green when belt-pack is powered on
•
Red when talk-lock is in use
•
Flashes green during channel programming
5. Power On / Off
•
Press to turn power to belt-pack on or off
6. Talk Lock
•
Used with a full-duplex system, press to activate hands-free com-
munication
munication
•
When car arrives at speaker post, press to activate. Communication
will automatically deactivate when car leaves speaker post and
automatically reactivate when next car arrives
will automatically deactivate when car leaves speaker post and
automatically reactivate when next car arrives
•
Press Talk 1 or Page to deactivate Talk Lock
•
Only 1 belt-pack at a time can use Talk Lock and no other headsets
can talk to the speaker post
can talk to the speaker post
•
Disabled or enabled by holding Talk Lock button down when the
headset is being powered up
headset is being powered up