Accton Technology WA4101ACC User Manual
B-1
Ac
c
c
e
ss Po
in
t
Po
rt a
rt a
n
d
Ne
tw
tw
or
k C
ab
les
ab
les
B
Access Point Port and Network Cables
This appendix includes access point connector information and network
cable information for cables that should be used with the AP 420 ww/na,
including minimum pin-out information and specifications for twisted-pair
cables.
cable information for cables that should be used with the AP 420 ww/na,
including minimum pin-out information and specifications for twisted-pair
cables.
N o t e
Incorrectly wired cabling is the most common cause of problems for LAN
communications. HP recommends that you work with a qualified LAN cable
installer for assistance with your cabling requirements.
communications. HP recommends that you work with a qualified LAN cable
installer for assistance with your cabling requirements.
Access Point Ports
The fixed RJ-45 10/100Base-TX port on the access point accepts 100-ohm
unshielded and shielded twisted-pair cable with RJ-45 connectors as
described on the next page.
unshielded and shielded twisted-pair cable with RJ-45 connectors as
described on the next page.
Twisted-Pair Cables
10 Mbps Operation
Category 3, 4, or 5 100-ohm unshielded twisted-pair (UTP)
or shielded twisted-pair (STP) cable, complying with IEEE
802.3 Type 10Base-T specifications, fitted with RJ-45
connectors
or shielded twisted-pair (STP) cable, complying with IEEE
802.3 Type 10Base-T specifications, fitted with RJ-45
connectors
100 Mbps Operation
Category 5 100-ohm UTP or STP cable, complying with
IEEE 802.3u 100Base-TX specifications, fitted with RJ-45
connectors
IEEE 802.3u 100Base-TX specifications, fitted with RJ-45
connectors