Honeywell International Inc. 50052669 User Manual
TL9160
5
Installation in a 4”x4” junction box
ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect AC power
before beginning installation.
Wiring must comply with local electrical codes. Use special CO/ALR solderless
connectors if the supply wires are made of aluminum.
before beginning installation.
Wiring must comply with local electrical codes. Use special CO/ALR solderless
connectors if the supply wires are made of aluminum.
1)
Mount the junction box on the wall. Punch
out a knockout on the side of the electrical
box where the AC wires come in. Punch
out another one or two knockouts for the
heater and supply wires. Install strain
relief bushings.
out a knockout on the side of the electrical
box where the AC wires come in. Punch
out another one or two knockouts for the
heater and supply wires. Install strain
relief bushings.
2)
Remove the locknut from the antenna and
peel off the adhesive backing. Feed the
antenna wires through a knockout and
mount the antenna vertically as shown.
Put the locknut and tighten.
peel off the adhesive backing. Feed the
antenna wires through a knockout and
mount the antenna vertically as shown.
Put the locknut and tighten.
3)
Peel off the adhesive backing of the relay
module and stick the relay inside the
electrical box with the relay wires directed
upwards (as shown).
module and stick the relay inside the
electrical box with the relay wires directed
upwards (as shown).
4)
Feed the supply wires and heater wires
through a knockout and connect them to
the relay module.
through a knockout and connect them to
the relay module.
5)
Insert the antenna plug in the relay
receptacle until you hear a click.
receptacle until you hear a click.
6)
Install a cover plate and apply power to
the heater. Do not put the antenna
cover back yet.
the heater. Do not put the antenna
cover back yet.
To heater
L2 L1 : For 240V application
N L : For 120V application
BlueB
lu
e
BlackB
la
ck
RedR
e
d
69-2474EFS (Honeywell YTL9160 System Installation Guide).book Page 5 Friday, April 29, 2011 12:04 PM