Murata Electronics North America 2410G User Manual

mode 00

 

Transparent mode used for point-to-point networks
or multipoint remotes; does not support any packet
types.

mode 01

 

This is the simplest protocol mode supporting Data
packets only. This mode is not recommended for
base radios. No 

CONNECT

 or 

DISCONNECT

packets are supported and no sequence numbers are
provided.

packet types supported:

Data

mode 02

 

This mode includes notification when remotes are
registered or dropped through 

CONNECT

 and

DISCONNECT

 packets that are sent to the user

application at the base station and at the remote.  No
sequence numbers are provided.

packet types supported:

Data

CONNECT
DISCONNECT

mode 04 

This is the packet format used by the WIT2400.
This allows legacy software to operate the
WIT2410 with a minimum of changes.  Note
however, that since different air data rates are used,
WIT2410s and WIT2400s cannot be mixed in a
network.

packet types supported:

2400 data format

  modes 05 – 08 

mode 09 

This mode sends the protocol mode 01 packets
during transmit but receives data transparently.

mode 0A 

This mode sends the protocol mode 02 packets
during transmit but receives data transparently.

mode 0C 

This mode sends the protocol mode 04 packet
during transmit but receives data transparently.

  modes 0D – 0F  reserved for future use.

mode 11 

This mode sends data transparently but supports
protocol mode 1 during reception.