Proxim Wireless Corporation GX800-23 User Manual
Save Configured Parameters
The configured parameters must be saved, so that they are valid even after the device restarts.
The IDU contains four memories. The first memory, referred to as W0, is the boot memory.
During the device startup, the link parameters are uploaded from this memory. The remaining
memories, referred to as W1, W2 and W3, can be used for configuration backup, testing
configuration and so on.
During the device startup, the link parameters are uploaded from this memory. The remaining
memories, referred to as W1, W2 and W3, can be used for configuration backup, testing
configuration and so on.
IP configuration is saved independently into W0 reboot memory only. IP configuration could be
saved either immediately after the IP setup or later in Web Interface under main menu
“Maintenance” menu and sub menu “Write“.
saved either immediately after the IP setup or later in Web Interface under main menu
“Maintenance” menu and sub menu “Write“.
For saving into the memory, click the relevant button Write_W0 to Write_W3.
!! Note !! To save configuration parameters, you can also click the “COMMIT” button
which is available on the top of every screen.
which is available on the top of every screen.
Save the new configuration into the relevant memory (Example boot memory W0) on the other
side of the terminal as well.
side of the terminal as well.
To run any saved configuration, click relevant button Run_W0 to Run_W3.
Tsunami™ GX800 Installation and Management Guide
35
Figure 35: Save Configured Parameters