Proxim Wireless Corporation L49U24U50 User Manual

Command Line Interface (CLI)

AP-4000/4000M/4900M User Guide

Configuring the AP using CLI commands

201

Set Rogue Scan Parameters

Perform the following command to enable or disable Rogue Scan on a wireless interface and configure the scanning
parameters.

The cycletime parameter is only configured for background scanning mode.

[Device-Name]>set rscantbl <3 or 4> mode <1 for background scanning, 2 for continuous
scanning> cycletime <cycletime from 1–1440 minutes> status <enable/disable>

NOTE: Rogue Scan cannot be enabled on a wireless interface when the Wireless Service Status on that interface is

shutdown. First, resume service on the wireless interface.

Set Hardware Configuration Reset Parameters

The Hardware Configuration Reset commands allows you to enable or disable the hardware reset functionality and to
change the password to be used for configuration reset during boot up.

To disable hardware configuration reset, enter:

[Device-Name]>set hwconfigresetstatus disable

To enable hardware configuration reset, enter:

[Device-Name]>set hwconfigresetstatus enable

To define the Configuration Reset Password to be used for configuration reset during boot up, enter the following
command

[Device-Name]>set configresetpasswd <password>

It is important to safely store the

NOTE: It is important to safely store the configuration reset password. If a user forgets the configuration reset password,

the user will be unable to reset the AP to factory default configuration if the AP becomes inaccessible and the
hardware configuration reset functionality is disable.

Set VLAN/SSID Parameters

Enable VLAN Management

[Device-Name]>set vlanstatus enable
[Device-Name]>set vlanmgmtid <1–4094>

[Device-Name]>show wifssidtbl (to review your settings)
[Device-Name]>reboot 0

Disable VLAN Management

[Device-Name]>set vlanstatus disable or
[Device-Name]>set vlanmgmtid -1
[Device-Name]>reboot 0

Add a Entry to the WIFSSID Table

[Device-Name]>set wifssidtbl <index> ssid <Network Name> vlanid <-1 (untagged) or 1–4094>
status enable