Proxim Wireless Corporation XB92WFR User Manual
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide
64
Figure 5-13 NAT
Given below is the table which explains NAT parameters and the method to configure the configurable parameter(s):
After configuring the required parameters, click OK and then COMMIT.
:
•
To enable Dynamic NAT, set the NAT Status to Enable. To enable Static NAT, set the NAT Status to Enable and
the Port Forwarding Status to Enable.
the Port Forwarding Status to Enable.
•
NAT uses the IP address of the wireless interface as the Public IP address.
To add entries in the NAT Port Bind Table, navigate to ADVANCED CONFIGURATION > Network > NAT > Static Port
Bind. The NAT Port Bind Table screen appears. Click Add in the NAT Port Bind Table screen. The following NAT Port Bind
Table Add Row appears:
Bind. The NAT Port Bind Table screen appears. Click Add in the NAT Port Bind Table screen. The following NAT Port Bind
Table Add Row appears:
Parameter
Description
Status
This parameter is used to either enable or disable NAT on an SU or an End Point A.
Dynamic Start Port
and Dynamic End Port
and Dynamic End Port
Represents the start and end port sessions originated from private to public host.
By default, the Dynamic Start Port is configured to 1 and Dynamic End Port is configured
to 65535. Configure the start and end port as desired.
to 65535. Configure the start and end port as desired.
: Care should be taken to avoid overlap of Dynamic Port range and Static Port
range.
Port Forwarding
Status
Status
This parameter is used to either enable or disable the Static NAT feature within different
networks. It allows public hosts to access hosts in a private network. By default, it is
disabled.
networks. It allows public hosts to access hosts in a private network. By default, it is
disabled.