Senstar Corporation LM100 User Manual

When you select the Connect button, the UCM status window displays. 

The following table includes the Senstar LM100 configuration parameters along with a brief 
description. The Sensor Head Configuration settings apply to all of the installed luminaires, unless 
the parameter is assigned to a specific segment or zone.

Refer to the UCM help file and the appropriate section in this document 
for additional details on configuring the Senstar LM100 and UCM 
operation.

Figure 47: UCM Status window

UCM menu selection
UCM fast access buttons
details about the connected gateway 
(green Comm Status Led indicates active UCM connection)

select Address to set the gateway’s Silver network address)

select Application to update the gateway or luminaire firmware

select a UCM tab to display or configure the selected properties

the Event Log contains the 500 most recent Events since the UCM
was connected

the Diagnostic Status field displays the results of ongoing self-tests

the Head Status field displays information about the luminaires on
the wireless mesh network

the Auxiliary Status field displays information about the gateway’s I/O

use the reset button to set the head supervision for their current 
installation locations