ZyXEL Communications Corporation CAM1215 User Manual
17
When the authentication method is set as Open or Shared, you need to select
the Default Key ID and then enter the WEP key(s) in the Key1/2/3/4 option.
the Default Key ID and then enter the WEP key(s) in the Key1/2/3/4 option.
When the authentication method is set as WPA-PSK or WPA2-PSK, you need
to enter the Shared Key that must match the Pre-shared key value in the
remote device.
to enter the Shared Key that must match the Pre-shared key value in the
remote device.
The SSID (Network ID) keeps the default setting of this option to connect the
camera to any access point under the infrastructure network mode. To connect
the camera to a specified access point, set a SSID for the camera in the SSID
option to correspond with the access point’s ESS-ID. To connect the camera to
an Ad-Hoc wireless workgroup, set the same wireless channel and SSID to
match with the computer’s configuration.
camera to any access point under the infrastructure network mode. To connect
the camera to a specified access point, set a SSID for the camera in the SSID
option to correspond with the access point’s ESS-ID. To connect the camera to
an Ad-Hoc wireless workgroup, set the same wireless channel and SSID to
match with the computer’s configuration.
When done, click Save.
PPPoE
This sub-menu is used when you use a direct connection via the ADSL modem.
Select the Enable option to enable this feature.
Select the Enable option to enable this feature.
To activate PPPoE mode, you should have a PPPoE account from your Internet
service provider. Enter the User Name and Password (twice). The camera will get
an IP address from the ISP as starting up.
service provider. Enter the User Name and Password (twice). The camera will get
an IP address from the ISP as starting up.
When done, click Save.
Filter
This sub-menu is used when you need to control access right in a certain IP
segment or specify the network communication protocol.
segment or specify the network communication protocol.
To add a designed filter, you should select the data packet access type of the
target and the communication protocol. Enter the Begin IP and End IP for dedicate
IP range. When done, click Add to append an item in your filter list.
target and the communication protocol. Enter the Begin IP and End IP for dedicate
IP range. When done, click Add to append an item in your filter list.
When done, click Save.