ZyXEL Communications Corporation EMG6765-Q10A User Manual

 Chapter 25 Maintenance

EMG6765-Q10A User’s Guide

Click Maintenance > Backup/Restore. Information related to factory defaults, backup configuration, 
and restoring configuration appears as shown next.

Figure 108   Maintenance > Backup/Restore 

The following table describes the labels in this screen.

Note: If you uploaded the default configuration file you may need to change the IP address 

of your computer to be in the same subnet as that of the default EMG6765-Q10A IP 

address (192.168.1.1). See 

 for details on how to set up your 

computer’s IP address.

Table 79   Maintenance > Backup/Restore

Backup Configuration

Backup

Click Backup to save the EMG6765-Q10A’s current configuration to your computer.

Restore Configuration

File Path 

Click Choose File to browse to the location of the configuration file in your computer.

Upload 

Click Upload to begin the upload process.

Note: Do not turn off the EMG6765-Q10A while configuration file upload is in progress.

After you see a “configuration upload successful” screen, you must then wait one minute before 
logging into the EMG6765-Q10A again. The EMG6765-Q10A automatically restarts in this time 
causing a temporary network disconnect.

If you see an error screen, click Back to return to the Backup/Restore screen.

Reset

Pressing the Reset button in this section clears all user-entered configuration information and 
returns the EMG6765-Q10A to its factory defaults.

You can also press the RESET button on the rear panel to reset the factory defaults of your 
EMG6765-Q10A. Refer to the chapter about introducing the Web Configurator for more 
information on the RESET button.