ZyXEL Communications Corporation P663HN51 User Manual
Chapter 10 Quality of Service (QoS)
P-663HN-51 User’s Guide
110
10.5.1 Configuring a QoS Class
Click Advanced > Quality of Service > QoS Classification and then the Add
or Edit button to configure a classifier. There are two sets of classification rules.
Set-1 is based on different fields within the TCP/UDP/IP layer plus the physical
or Edit button to configure a classifier. There are two sets of classification rules.
Set-1 is based on different fields within the TCP/UDP/IP layer plus the physical
Dest. Addr./Mask
This is the IP address (and optionally the subnet mask) of the device
that the traffic is going to.
that the traffic is going to.
Dest. Port
This is the port number on a device to which the traffic is going.
Source MAC
Addr./Mask
Addr./Mask
This is the MAC address (and optionally the subnet mask) of the
device that sent the traffic.
device that sent the traffic.
Dest. MAC Addr./
Mask
Mask
This is the MAC address (and optionally the subnet mask) of the
device that the traffic is going to.
device that the traffic is going to.
802.1P
This is the IEEE 802.1p mark on the traffic.
Order
This is the classifier’s place in the classifiers list.
Enable / Disable
The classifier is active when this check box is selected.
Remove
To remove an entry, select its Remove check box and click the
Remove button.
Remove button.
Add
Click this button to go to a screen where you can configure settings for
a new QoS queue.
a new QoS queue.
Remove
To remove an entry select its Remove check box and click the
Remove button.
Remove button.
Save/Apply
Click this button to save the changes and have the ZyXEL Device start
using them.
using them.
Table 38 Advanced > Quality of Service > QoS Classification (continued)
LABEL
DESCRIPTION