COOPER INDUSTRIES INC LPD24RC User Manual
8
DMAN-xxxx-xx
www.omnexcontrols.com
call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash
Flash
Fast
Flash
Flash
Red
Light
Light
Green
Light
Light
Alternating Red
& Green Light
& Green Light
Yellow
Light
Light
A.
ESTOP FAULT LINK STATUS
A. Supply power to the re-
ceiver. The (E-Stop) light
and the (Link) light will
come on RED and the
(Status) light will come on
GREEN
and the (Link) light will
come on RED and the
(Status) light will come on
GREEN
3. Power R2160
A. Hold [Power] switch UP
B. Press [E-Stop]
C. Twist CW & release [E-Stop]
D. Release [Power] Switch
4. Power T2300 into Configuration
D.
NOTE: If left idle in Setup Mode for over 30 seconds, the receiver will time out. The (Link) light and (Status) light will flash RED rap-
idly. To return to Setup Mode, repeat step 5.
idly. To return to Setup Mode, repeat step 5.
A. Press & hold [Setup] button
until (Status) light goes from
slow flash to fast flash
slow flash to fast flash
B. Release [Setup] button.
(Status) light goes to solid
GREEN, (Link) light turns off
GREEN, (Link) light turns off
ESTOP FAULT LINK STATUS
Setup
Button
A.
ESTOP FAULT LINK STATUS
Setup
Button
B.
5. Put R2160 into Setup
6. Download ID Code
ESTOP FAULT LINK STATUS
A. Press [Power] switch UP
and release
B. (Link) light goes to GREEN.
Once complete, (Link) light
goes to RED as the trans-
mitter turns off
goes to RED as the trans-
mitter turns off
B.
B.
A.
C.
0
A.
NOTE: For this document, orientation
of the paddle and switch operation will
be defined as follows:
Paddle UP—is towards the switches
Paddle DOWN—is away from switches
Switch UP—is away from paddles
Switch DOWN—is towards the paddles.
of the paddle and switch operation will
be defined as follows:
Paddle UP—is towards the switches
Paddle DOWN—is away from switches
Switch UP—is away from paddles
Switch DOWN—is towards the paddles.
UP DOWN