Kiddesigns Inc BE826 User Manual
9. Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are
not spilled into the enclosure through openings.
10. Damage Requiring Service - The appliance should be serviced by qualified service
personnel when:
A. The power-supply cord or plug has been damaged.
B. Objects have fallen into or liquid has been spilled into the enclosure.
C. The unit has been exposed to rain.
D. The unit has been dropped or the enclosure damaged.
E. The unit does not appear to operate normally or exhibits a marked change in
A. The power-supply cord or plug has been damaged.
B. Objects have fallen into or liquid has been spilled into the enclosure.
C. The unit has been exposed to rain.
D. The unit has been dropped or the enclosure damaged.
E. The unit does not appear to operate normally or exhibits a marked change in
performance.
11. Servicing - The user should not attempt to service the unit beyond that described in the
user’s operating instructions. All other servicing should be referred to qualified service
personnel.
personnel.
Installation
Note: The BE-826 base is operating by AC supply and the wireless MIC is operating by DC
supply. To ensure the wireless MIC operation, you must install 2 “AAA” batteries. Read
through this Instruction Book carefully before install battery or plug in AC adapter.
through this Instruction Book carefully before install battery or plug in AC adapter.
Battery installation
1. Switch the wireless MIC Power On/Off switch to Off position.
2. Open the battery door on the wireless MIC by screw driver.
3. Install 2 “AAA” alkaline batteries, while making sure that the polarity is correct as shown
2. Open the battery door on the wireless MIC by screw driver.
3. Install 2 “AAA” alkaline batteries, while making sure that the polarity is correct as shown
within the battery compartment.
4. Close the battery compartment door.
We recommend
We recommend
• Removing batteries if unit is not used for more than 30 days.
AC Power Connection
1. Switch the Base Power On/Off switch to Off position.
2. Plug-in the adaptor to the wall power plug then connect to the DC jack located on the back of
2. Plug-in the adaptor to the wall power plug then connect to the DC jack located on the back of
the Base unit.
Maintenance
z
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
z
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth
or other protective material should be placed between it and the furniture.
z
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning
agents, such as Benzine, thinner or similar materials can mar the surface of the case.
Connect to you TV/VCR
Important – You must connect the BE-826 to your TV/VCR to show pictures and sound. Your
TV/VCR must have AV input connector.
1. Using the AV cable to connect the BE-826 Base unit to your TV or VCR. Must sure color on
TV/VCR must have AV input connector.
1. Using the AV cable to connect the BE-826 Base unit to your TV or VCR. Must sure color on
the wires is matching to your TV/VCR connector.
2. If you have MONO TV/VCR only then you can switch the MONO/ST. switch to MONO and
just connect the white wire. On the other hand, switch the MONO/ST. switch to ST.
3. Make sure to set your TV/VCR properly to show AV input.