Davis Instruments DWW6357 User Manual
Preparing the ISS for Installation
7
Confirm the Transmitter ID of the ISS
In order to communicate, the console and ISS must have the same Transmitter ID. At
the factory, both IDs are set at a default of number 1. If you need to confirm the Trans-
mitter ID of your Vantage Vue ISS, follow these steps.
the factory, both IDs are set at a default of number 1. If you need to confirm the Trans-
mitter ID of your Vantage Vue ISS, follow these steps.
Looking at the underside of your Vantage Vue ISS, locate the Transmitter ID Pushbut-
ton and the Transmitter ID LED, as shown in the figure below.
ton and the Transmitter ID LED, as shown in the figure below.
1. Push the Transmitter ID
Pushbutton once.
2. Note the number of times
Transmitter ID LED
blinks.
blinks.
Unless you have inten-
tionally changed your
transmitter ID, the LED
should blink one time
because the default Trans-
mitter ID for the ISS is
“1.” If you have changed the ID, the LED should blink the number of times equal
to the ID you have set (i.e., twice for an ID of ‘2,’ three times for an ID of ‘3,’ etc.).
tionally changed your
transmitter ID, the LED
should blink one time
because the default Trans-
mitter ID for the ISS is
“1.” If you have changed the ID, the LED should blink the number of times equal
to the ID you have set (i.e., twice for an ID of ‘2,’ three times for an ID of ‘3,’ etc.).
Note:
The transmitter on the ISS and receiver on the console will communicate with each other only when both
are set to the same Transmitter ID.
are set to the same Transmitter ID.
Set a New Transmitter ID on the ISS
Note:
In most cases, it will not be necessary to change the Transmitter ID. If it is necessary to change the Trans-
mitter ID, you must use the same ID for the ISS and console.
mitter ID, you must use the same ID for the ISS and console.
To set a new transmitter ID, follow these steps.
1. Push and hold the Transmitter ID button until the LED begins blinking quickly.
2. Release the button, and the LED will stop blinking.
3. Push the button the number of times equal to your desired new transmitter ID.
2. Release the button, and the LED will stop blinking.
3. Push the button the number of times equal to your desired new transmitter ID.
That is, if you want to change the ID to ‘3,’ push the button three times, and for a
desired ID of ‘4,’ push the button four times.
desired ID of ‘4,’ push the button four times.
After four seconds have elapsed with no further presses, the LED will blink the
same number of times as the new transmitter ID.
same number of times as the new transmitter ID.
Note:
If you hold the button too long and accidentally enter the “set new transmitter ID” mode when you did not
want to, simply release the button and wait four seconds. As long as you do not press the button again,
the original transmitter ID will remain in effect.
want to, simply release the button and wait four seconds. As long as you do not press the button again,
the original transmitter ID will remain in effect.
Transmitter ID
Button
Transmitter ID
LED