Davis Instruments DWW6357 User Manual
General ISS Installation Guidelines
11
Installation Instructions
The Vantage Vue ISS can only be mounted on the top of a pole or solid round bar that
is between 1.0 and 1.8 inches (25 - 46mm) in outside diameter.
is between 1.0 and 1.8 inches (25 - 46mm) in outside diameter.
Recommended Accessories for Pole Mounting
• Use the Mounting Tripod (#7716) for easy roof-mounting.
• Use the Mounting Pole Kit (#7717) to raise the installation height of the ISS by
• Use the Mounting Pole Kit (#7717) to raise the installation height of the ISS by
up to 37.5" (0.95 m).
General Guidelines for Installing on a Pole
• With the supplied U-bolt, the ISS can be mounted on a pole having an outside
diameter ranging from 1" to 1.8" (25 – 46mm).
• To mount on a smaller pole, obtain a U-bolt that fits the base openings but that
has a longer threaded section. If mounting the ISS on a smaller pole with the
included U-bolt, the threaded sections of the U-bolt will be too short to securely
mount the ISS.
included U-bolt, the threaded sections of the U-bolt will be too short to securely
mount the ISS.
.
Installing the ISS on a Pole
1. If you are mounting your ISS on a Davis Mounting Tripod (product number 7716)
or the pole included with a Davis Mounting Pole Kit (product number 7717),
follow the instructions included with those Davis products for proper installation.
If you are not using one of these Davis products, mount any galvanized steel pole
having an outside diameter ranging from 1" to 1.8" (25 – 46mm), following the
guidelines explained in “General ISS Siting Guidelines” on page 9.
follow the instructions included with those Davis products for proper installation.
If you are not using one of these Davis products, mount any galvanized steel pole
having an outside diameter ranging from 1" to 1.8" (25 – 46mm), following the
guidelines explained in “General ISS Siting Guidelines” on page 9.
2. Using the illustration above as a guide, hold the ISS so that the Wind Cups and
Radiation Shields are on the left and gently place the ISS on top of the steel pole.
3. While holding the mounting base of the ISS against the pole, place the two ends of
the U-bolt around the pole and through the two holes in the C-shaped bracket on
the base.
the base.