Davis Instruments DWW6800 User Manual

10

• While the Gateway is searching for signals, the LED lights will flash. 
• When the signals are acquired, the LEDs will stop flashing and stay on. After 

several minutes, the solid LED lights will time out and go off.

If there is a connection error, the lights will flash quickly. Their behavior will 
indicate the type of error. 

Note: 

The LED lights can be reactivated by pressing and releasing the blue status LED on/
off button. After pressing the button, wait for up to 30 seconds for lights to come on. 
Do not hold the button down.

The Gateway will now begin to acquire the cell signal. As this is occurring, you 

may see the lights go on an off or blink, but after about a minute, the lights will 
begin to indicate the status of your connections. You will be able to use the lights 
to verify connection or troubleshoot connection problems by watching the LED 
lights.

The lights flash when Gateway is searching for a signal from the weather station 

(upper LED) or a cell signal (lower LEDs). Once the signal is detected, all four cell 
status lights will turn solid and stay on for a few minutes, indicating success. It can 
take several minutes to acquire all signals.

1. Make sure the Bluetooth function on your smartphone is on. 
2. Open the app and tap “Add a Gateway.”
3. Bring the phone close to the Gateway or tap it gently on the Gateway.
4. Follow the prompts as the Gateway is located and connection is made between 

the Gateway and your account on WeatherLink.com.