Davis Instruments DWW765Y User Manual

9

Use this table to determine which ID the transmitter is using based on the position of 
the #1, 2, and 3 switches on the DIP switch. 

3. Use the “Transmitter and Repeater ID Worksheet” to record the transmitter ID.

If there is any reason that the transmitter ID needs to be set to another channel, the DIP 
switch should be set now to the desired ID.

To change to another ID:

1. Use a paper clip to toggle DIP switches #1, 2, and 3 using the Transmitter ID table 

above to change the station to the desired transmitter ID.

The transmitter ID can be changed if any of the following issues are true: 

‰

Another Davis Instruments wireless weather station operating nearby already 
uses transmitter ID 1. 

‰

Additional wireless transmitting stations have been purchased with the Vantage 
Pro2 or Vantage Pro2 Plus and one of the stations has been designated as Station 
No. 1 instead of the selected ISS. 

If the station is too far away or in an inconvenient location, making it hard to view the 
transmitter ID from the station, the console can be used to determine the transmitter ID.

To find the transmitter ID using the console:

1. Place the repeater in an area where it is likely to receive the transmitter signal.

2. On the console, press the Done and down arrow (-) keys at the same time. The first 

screen in the Setup Mode is displayed. This screen locates and eventually displays all 
the active transmitter IDs the console is receiving. See the Vantage Pro2 Console 
Manual for more information about the Setup Mode and the Active Transmitter screen 
if necessary.

3. Record the value of the transmitter ID.