Xircom EAG2919 User Manual
Eagle II GSM Radio Module Technical Manual Preliminary Draft: 08/31/00
15
Part Number: 07100017 version 00.04
© 2000 Xircom, Inc. All rights reserved.
All trademarks and copyrights are the property of Xircom, Inc.
All trademarks and copyrights are the property of Xircom, Inc.
Mating Connector on the Carrier Board of the Application
The carrier board must provide a mating 60-pin connector. The following table describes
the recommended connectors:
the recommended connectors:
Vendor P/N
Description
Manufacturer
Tube Package
Tape Package
60 pin female
AMP (717) 564-0100
177983-2
177985-2
60 pin female
Berg (800) 237-2374
61082-061000
61082-061002
Note: The nominal PCB-to-PCB connector stack height (provided by the Eagle II
module) is 8 mm (0.315 inches). If required, mating connectors with 12 mm and
16 mm stack heights are available from the listed manufacturers. When using
higher stack height connectors, the mating carrier board must provide standoffs to
accommodate the increased connector stack height.
module) is 8 mm (0.315 inches). If required, mating connectors with 12 mm and
16 mm stack heights are available from the listed manufacturers. When using
higher stack height connectors, the mating carrier board must provide standoffs to
accommodate the increased connector stack height.
I/O Signal Connector on the Eagle II Module
The Eagle II module communicates with the carrier board of the application via the 60-pin
I/O signal connector. The following table describes the pin assignments for the connector,
sorted by functionality.
I/O signal connector. The following table describes the pin assignments for the connector,
sorted by functionality.
I/O Connector Pin Assignments, Sorted by Functionality
Pin
Number
Signal
Name
Direction
Functionality
Voltage
Level
Power
1, 2, 3, 4, 5, 6
VIN
From CPE
Electrical power input to Eagle II module:
4.2 VDC to 5.2 VDC
Refer to the table for Operating Power.
21, 24, 25, 28, 29,
33, 44, 45, 48, 49,
52, 53, 57
GND
From CPE
Electrical power return for digital and analog grounds.
Reset/Primary Serial I/O
23
RESET_B
From CPE
Reset Input. Active Low. Internally pulled high and can be
left disconnected if not used. If connected to external
circuitry, maximum high level must not exceed 3.3 V.
Pulse width must be at least 5 mS to guarantee a valid
reset.
3 V *
8
RX0
To CPE
Receive data 0. DCE Output signal. Main serial interface
transmit data signal. During idle or reset, signal will be a
logic 1. Connects to a DTE, RX, receive data pin.
3 V