Audio-Technica Corporation T3202DE2 User Manual

2

•  To prevent fire or shock hazard, do not expose this apparatus to rain or moisture.

•  Do not expose this apparatus to drips or splashes.  

•  To avoid electric shock, do not open the cabinet.

•  Refer servicing to qualified personnel only.

•  Do not expose this apparatus to excessive heat such as that generated by 

sunshine, fire or other heat sources.

•  Do not subject this apparatus to strong impact.

•  This apparatus should be located close enough to the AC outlet so 

that you can easily grasp the AC adapter at any time.  

•  In case of emergency, disconnect the AC adapter quickly.

•  Do not place any objects filled with liquids, such as vases, on this apparatus.

•  To  prevent fire, do not place any naked flame sources (such as 

lighted candles) on this apparatus.

•  Do not install this apparatus in a confined space such as a bookcase 

or similar unit.  

• Install this apparatus only in the places with good ventilation.  

• The rating label is put on the bottom of this apparatus. 

•  Keep batteries out of the reach of children.  

•  Observe correct polarity as marked.

•  Do not expose the battery to excessive heat such as sunshine, fire or 

the like.

•  Always consider the environment issues and follow local 

regulations when disposing of batteries.

•  Remove depleted battery immediately.

•  Danger of explosion if battery is incorrectly replaced. Replace only 

with the same or equivalent type.

•  Use only disposable LR06(AA) alkaline or Ni-MH batteries.

•  Do not use new batteries and old one at the same time.

•  Do not use different batteries type or model.

•  Do not use a leaking battery. If battery leakage occurs, avoid 

contact with skin.

 If contact occurs, immediately wash thoroughly 

with soap and water

•  If battery leakage comes into contact with your eyes, immediately 

flush with water and seek medical.

This device complies with Part 15 of the FCC Rules. Operation is 

subject to the following two conditions: (1) This device may not cause 

harmful interference, and (2) this device must accept any interference 

received, including interference that may cause undesired operation.

You are cautioned that any changes or modifications not expressly 

approved in this manual could void your authority to operate this 

equipment.

Note: This equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to part 15 of the FCC 

Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and 

on, the user is encouraged to try to correct the interference by one or 

more of the following measures:
- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-  Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

CAN RSS-Gen/CNR-Gen 

This device complies with INDUSTRY CANADA R.S.S. 210. Operation 

is subject to the following conditions: (1) This device may not cause 

harmful interference and (2) this device must accept any interference 

received, including interference which may cause undesired operation.

This device complies with RSS-102 radiation exposure limits set forth 

for an uncontrolled environment.