KAPSCH TRAFFICCOM CANADA INC. 801660A User Manual
Sheet 5 of 5
General Procedure for Application of Dual Lock® and/or 3M™ VHB™ Tape
•
Minimum adhesive application temperature to bonding surface shall be 15°C or higher. Initial tape application
temperature below the suggested minimum is not recommended because the adhesive becomes too firm to adhere
readily.
temperature below the suggested minimum is not recommended because the adhesive becomes too firm to adhere
readily.
•
Clean bonding surface with rubbing alcohol and dry. Surface must be free of moisture and any surface contaminants.
•
Carefully remove the protective backing paper from the adhesive strips on the rear side of the OBU or secure bracket
and firmly press it against the glass. Maintain the pressure for about 15 seconds to achieve a good bond.
and firmly press it against the glass. Maintain the pressure for about 15 seconds to achieve a good bond.
•
Once the adhesive is applied to the windshield, do not remove the item from the windshield and reuse it. Obtain new
strips from your nearest Customer Service Center.
strips from your nearest Customer Service Center.
•
Allow the adhesive to cure on the windshield for 20 minutes prior to any removal of the OBU.