Worthdata Inc B78 User Manual
21
The following parameters apply base station attached serially.
Baud rate
300 0
600 1
1200 2
2400 3
4800 4
9600 5
19,200 6
600 1
1200 2
2400 3
4800 4
9600 5
19,200 6
Data bits
7 Bits
0
8 Bits
1
Set the data bits ("word length") to the same setting your terminal is using, or
you want to use with your serial port.
Parity
None 0
Even 1
Odd 2
Even 1
Odd 2
Set parity to the same setting your terminal is using, or the one you want to use
with your serial port. None is usually used in conjunction with 8 data bits,
Even or Odd with seven data bits.
Stop bits
1 Bit
0
2 Bits
1
Set the stop bits to the same setting your terminal is using, or you want to use
with your serial port.
Transmission mode
Full Duplex
0
Half Duplex
1
This applies to use of the "F45-1 Serial Y Cable" only. "Full Duplex" means
that the R/F Reader will transmit data only through the HOST connector. With
"Half Duplex", data is transmitted through the HOST and TERM connectors.
Full Duplex should be used in almost all cases, but Half Duplex. 0 is useful for
testing pin-out reversal.