Regler Ltd MTX User Manual
MTX operational instructions
The MTX transmitter is designed to be a low cost solution to revive an LED wristband after its
primary use at a concert. This allows the user to turn the LED wristband on using the radio frequency
transmission and control the LED parameters and effects by pressing the associated buttons.
primary use at a concert. This allows the user to turn the LED wristband on using the radio frequency
transmission and control the LED parameters and effects by pressing the associated buttons.
Items required-
1x MTX transmitter
1x RGB Xylobands.
Instructions-
1. Turning on the transmitter.
To turn on the MTX you need to press and hold the power button for 10 seconds. This will
turn the display LED red and then send a repeat RF transmission. This RF transmission repeats for a
further 10 seconds and communicates to the receiver to go from the dormant “Sleep” mode to the
“Wake” mode. This process is indicated by a dim flashing red led on the transmitter
further 10 seconds and communicates to the receiver to go from the dormant “Sleep” mode to the
“Wake” mode. This process is indicated by a dim flashing red led on the transmitter
2. Sending an effect parameter
Once step 1 is complete, the buttons on the MTX will send packets of data to the wristband
performing the desired action displayed in the table below-
Button
Action
Yellow colour button
Turn’s the wristband effect Yellow
Red Colour button
Turn’s the wristband effect Red
Magenta Colour Button
Turn’s the wristband effect Magenta
Green Colour button
Turn’s the wristband effect Green
Blue Colour button
Turn’s the wristband effect Blue
White colour button
Turn’s the wristband effect White
Mix Colour button
Turn’s the wristband effect a mixture of the
above colours
Beat Tap Button
Send’s a single transmission for the wristband
to flash once
Twinkle button
Allows a group of wristbands to flash
sequentially to get a twinkle effect
Beat button
Makes the wristband flash continuously
Heartbeat Button
Makes the wristband flash twice and then is off
for a small period before repeating the
sequence. This symbolises a “Heartbeat”
Random Effect button
Makes the wristbands flash in a random
sequence at a designated speed
All on Button
Turns the wristbands on
Glow button
Allows the wristbands to perform a glow
sequence
Strobe button
Makes the wristbands strobe fast
Stop Button
Stops the current effect