Pantech 78 User Manual

174 

This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2)  This device must accept any interference received. Including interference that 

may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class 

B digital device pursuant to Part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful Interference in a residential 

installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may 

cause harmful Interference to radio communications. However, there is no

guarantee that interference will not occur in a particular Installation. If this 

equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged 

to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.   

 

Increase the separation between the equipment and receiver.

•  Connect the equipment into an outlet of a circuit different from that to which 

the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for assistance.

  

Changes or modification not expressly approved by the party responsible 

for compliance could void the user’s authority to operate the equipment. 

Connecting of peripherals requires the use of grounded shielded signal 

cables.