Hughes Network Systems HNS9202 User Manual
8
Using the Hughes 9
Revision 0.2
When WLAN is enabled, unauthorized users may be able to
access your BGAN service. If WEP is enabled, you must
provide other WLAN users with the WEP key in order for
them to connect to the terminal. You can go to the Manage
Connections page to see what computers are actually using the
BGAN service.
access your BGAN service. If WEP is enabled, you must
provide other WLAN users with the WEP key in order for
them to connect to the terminal. You can go to the Manage
Connections page to see what computers are actually using the
BGAN service.
Connecting by ISDN
Connect an ISDN cable to your computer‘s or phone‘s ISDN
port, and insert the other end of the connector into the
Terminal‘s ISDN port.
port, and insert the other end of the connector into the
Terminal‘s ISDN port.
To dial, prefix the international number with 00 and terminate
with #. For example, to dial a number in the USA, enter:
0018005551234# (00 + Country code + phone number #). For
the UK dial 00011442077281000#.
with #. For example, to dial a number in the USA, enter:
0018005551234# (00 + Country code + phone number #). For
the UK dial 00011442077281000#.
To receive incoming calls you must configure your ISDN
device with the MSN (Multiple Subscriber Number) of the
service it supports. See the ISDN section for information on
configuration of MSNs. To configure the MSN in your ISDN
device, refer to the user guide of your ISDN device.
device with the MSN (Multiple Subscriber Number) of the
service it supports. See the ISDN section for information on
configuration of MSNs. To configure the MSN in your ISDN
device, refer to the user guide of your ISDN device.
Connecting by RJ-11
You can connect an analog phone or fax machine to the RJ-11
ports:
ports:
The FAX port is configured for 3.1k service for fax
The TEL port is configured for speech service for voice calls
To dial, prefix the international number with 00 and terminate
with #. For example, to dial a number in the USA, enter:
0018005551234# (00 + Country code + phone number #)
with #. For example, to dial a number in the USA, enter:
0018005551234# (00 + Country code + phone number #)
Operational note: RJ-11 and ISDN handsets cannot be
connected at the same time.
connected at the same time.
The 9202 will configure itself to
ISDN or RJ-11 mode depending on which type of handset is
plugged in first, and will be in this mode thereafter.
plugged in first, and will be in this mode thereafter.
To switch modes, the 9202 must be rebooted with only the
desired handset connected. If both types of handsets are
connected at power-on, the 9202 will default to ISDN mode
and RJ-11 will not be operational.
desired handset connected. If both types of handsets are
connected at power-on, the 9202 will default to ISDN mode
and RJ-11 will not be operational.