JVC KENWOOD Corporation 37663210 User Manual

18

Selective Call is enabled or disabled by your dealer.  This function is similar to
Code Squelch {page 17}.  The differences from Code Squelch are:

• You can send or receive Status codes containing up to 5 digits.
• Selective Call opens the squelch only when the transceiver receives a predetermined

DTMF code in the correct sequence (3-digit or 4-digit ID code — 1-digit Intermediate
code — Status code of up to 5 digits).

Your dealer may also activate Group Call for your transceiver.  This is useful
when you want to send information to a number of units in a fleet.  Ask your
dealer for details.

Note:  Selective Call cannot be used on this transceiver if Code Squelch {page 17} or DTMF Number
Display {page 23} have been programmed.

When you receive the correct ID and Intermediate codes, the squelch opens and
you will hear the call.  If a Status code is also received, the code will appear on
the display.  For example, if the Status code “12345” was received, “

”

appears on the display. (“ ” appears in place of “ ” for group calls.)

• The 

 icon appears on the display and blinks.

• When no Status code is received “

” appears on the display.

• You can clear the Status code by pressing any key or returning the microphone to its hook.
• To mute the speaker after squelch opens, press the key programmed as Monitor.
• Your dealer can program the transceiver to mute the speaker after a specified time

period elapses.

• If Transpond is programmed, an acknowledgment signal is returned to the calling

station.  Transpond does not function when you are called with a Group code.
Transpond can send an alert tone, a transceiver ID code, or autodial memory location
number 1 (refer to “S

TORING

 DTMF N

UMBERS

” on page 14).

• If Call Alert is programmed, an alert tone will sound when the correct code is received.

1 Press and hold the PTT switch.
2 Enter the ID code (or Group code) and Intermediate code of the transceiver

you want to call on the microphone keypad.

• If desired, you can also enter a Status code of up to 5 digits.
• You can send codes the same way you make DTMF calls {page 14}.

3 Use the transceiver the same as in a regular call; press the PTT switch to

transmit and release it to receive.

• The 

 icon appears on the display.

• When you release the PTT switch, the squelch opens.  If no signal is received for a

pre-determined time, the speaker will mute.

• Pressing the key programmed as Monitor at any time will mute the speaker.