Yaesu Musen Co. Ltd. HX470SA User Manual

Page 22

1. Install the belt clip on the transceiver according to the description in the

box below, if desired.

2. Install the nylon carrying strap on the belt clip, if desired.
3. Install the battery pack on the transceiver (see section 4.1.3 “BATTERY

INSTALLATION/REMOVAL”).

NOTE: Water resistance of the transceiver is assured only when the
battery pack is attached to the transceiver and MIC/SP rubber cap is
installed in the MIC/SP jack.

1. Connect the hanger to the rear of the HX470S, with the notch

pointing directly up, using the supplied screw (Figure 1).
Use only the screw included with the clip to mount the clip to
the back of the transceiver!

2. Clip the Quick Draw Belt Clip to your belt (Figure 2).
3. To install the HX470S into the Quick Draw Belt Clip, align the

hanger with the Quick Draw Belt Clip and slide the HX470S into
its slot until a click is heard.

4. To remove the HX470S from the Quick Draw Belt Clip, rotate the

HX470S 180 degrees, then slide
the transceiver out from the Quick
Draw Belt Clip (Figure 3).

ñ

ò