Acumen Technologies Ltd 10305 User Manual

National Electirc Code ANSI/NFPA No. 70-current (In the United States), or with the current CSA C22.1 

Canadian Electirc Code (in Canada).   

 
WARNING: TURN ELECTRICAL POWER OFF AT THE CIRCUIT BEAKER BEFORE BEGINNING THIS 
INSTALLATION. 
 

1.  Connect the electrical service wires to the junction box of the fireplace. 

2.  Place the receiver onto the base pan of the fireplace. 

Connect the wires labeled “ Main Valve” to the Millivolt generator and Millivolt valve (see Fig.1) or the 

Emergency Switch (Fig.2). Switch the Emergency Switch to OFF position if it is installed. Use the 

Emergency Switch only during a power failure.

 

 

Millivolt 
Generator

 

4.  Plug the cord from the blower (2-prong male plug) into the black cord (2-hole female plug end) of the 

receiver. 

5.  Plug the orange cable labeled “Solenoid” to the modulation solenoid of the gas valve. See Fig. 3. 

 

 

Figure 3 

 

6. 

Slide the slide switch at the bottom of the Receiver to NG for natural gas and LPG for Liquid petroleum 

gas. 

7. 

Plug the black cord (2-prong male plug end) of the receiver into the junction box. 

8.  Turn the electrical power ”ON” at the circuit breaker. 

9.    Follow the Lighting Instruction section in the fireplace instruction manual. Be certain that the pilot light is 

on and the gas control valve is in the ”ON” position. 

 
The WMT 103 Remote Control has 3 operating modes. They are: Manual, Auto, Timer.