Crestron Electronics Inc TX3 User Manual

As of the date of manufacture, the PTX3 has been tested and found to comply with specifications for CE 

marking and standards per EMC and Radiocommunications Compliance Labelling.

Specifications subject to

change without notice.

 

15 Volvo Drive, Rockleigh, NJ 07647

Tel: 888.CRESTRON 

Fax: 201.767.7576

www.crestron.com

This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:

(1) This device may not cause harmful interference and (2) this device must accept any interference 

received, including interference that may cause undesired operation.

To satisfy RF exposure requirements, this device and its antenna must operate with a separation distance  

of at least 20 centimeters from all persons and must not be colocated or operating in conjunction with any 

other antenna or transmitter.

CAUTION:  Changes or modifications not expressly approved by the manufacturer responsible for 

compliance could void the user’s authority to operate the equipment. 

NOTE:  This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help

Operation is subject to the following conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may cause undesired operation 

of the device.