Korea Data Systems Co Ltd KL1723BM User Manual
GETTING ST
AR
TED
GETTING ST
AR
TED
GETTING ST
AR
TED
GETTING ST
AR
TED
CONTROL BUTTONS
5
Follow these steps to install the monitor
1. Before you connect the the cables, make sure the monitor and system
unit power switches turn off.
unit power switches turn off.
2. Plug the 15-pin signal cable or 24-pin DVI cable between the rear of
your Monitor and system. The adapter may be required for certain Apple
Macintosh computers. Tighten the two screws on the cable connector.
your Monitor and system. The adapter may be required for certain Apple
Macintosh computers. Tighten the two screws on the cable connector.
3. Plug the Audio Cable between Audio input Jack in the rear of your
monitor and audio output of your system.
monitor and audio output of your system.
4. Connector the power cord to the inlt socket which is located at the AC
adapter. Connector the plug into an AC wall outlet.
adapter. Connector the plug into an AC wall outlet.
5. Connector DC Plug of AC Adapter to the DC Jack which is located at
the rear of your monitor.
the rear of your monitor.
INSTALLATION
OSD Buttons
: The OSD control keys are located on lower left of the
monitor.
((E
En
ntte
err))
a. No OSD : This button will enable the main OSD menu.
b. Main OSD menu : Press this button to enter to the selected OSD
b. Main OSD menu : Press this button to enter to the selected OSD
control menu.
c. Cotrol OSD menu : Swap the control item.
o
orr ((U
Up
p/
/D
Do
ow
wn
n)) : Use these buttons to increase or decrease each value.
a. No OSD :
- : Contrast & Brightness control menu will be shown. Press ' '
(Enter) to switch to another menu between Contrast and
Brightness.
Brightness.
- : Audio volume & TEXT/MOVIE control menu will be shown.
Press 'MENU' to switch to another menu between Volume and
TEXT/MOVIE.
TEXT/MOVIE.
b. Main OSD menu : Use these button to move up (or down)the OSD
selection menu and adjust the attribute of the monitor while in OSD
mode.
mode.
((A
Au
utto
o))
a. No OSD : This button can be used to 'Auto Adjustment' function. (Size,
Phase)
b. Main OSD menu : Press this button to exit from the main OSD menu.
c. Control OSD Menu : Return to the previous menu.
c. Control OSD Menu : Return to the previous menu.
Press "AUTO" for 3 sec to select proper video input
signal either D-SUB or DVI.
signal either D-SUB or DVI.