DEI Headquarters Inc. HYU1800 User Manual
Page-5
Connections
We strongly recommend soldering all of the remote starter connections that are not done with the T-harness provided.
1.
Cut the wire you wish to connect to the right length and remove approximately 3.8 cm (1.5 inch) of insulation at its end
Cut the wire you wish to connect to the right length and remove approximately 3.8 cm (1.5 inch) of insulation at its end
(B).
2.
Twist the wire (B) around, making sure to expand the connection pad to the entire length of the exposed part of the source
wire (A).
wire (A).
B
B
A
3.
Solder the connection, making sure to properly heat both wires beforehand.
Solder the connection, making sure to properly heat both wires beforehand.
4.
Use electrical tape to isolate your connection. Ensure you let the wires cool down from the soldering process before you
proceed, so as to avoid melting the electrical tape.