Digital Security Controls Ltd. 005501Z32433 User Manual
14
O T H E R P R O G R A M M I N G
To restore the PC5132 programming to the factory default settings, perform the
following:
following:
1. Enter [✱][8] [Installer’s Code].
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. Press [#]. The software for
the receiver section will be restored to its factory default settings.
4. Press [#] to exit Installer Programming. After a software default, you must exit
and then re-enter Installer Programming before attempting to program the
receiver section.
receiver section.
For instructions on restoring the default programming of the control panel or any
other connected module, see your system
other connected module, see your system
Installation Manual.
O T H E R P R O G R A M M I N G