Digital Security Controls Ltd. 01NB5132 User Manual
9
O T H E R P R O G R A M M I N G
4.4 RF Jam Detect Zone
For RF jamming detection to work, you must select an unused zone to be used
as the RF Jam Detect zone. When the receiver detects an attempt to jam the RF
signal, the RF Jam Detect zone will be violated and the system will generate a
tamper signal. When the jamming signal is gone, the RF Jam Detect zone closes
and the system sends a tamper restore signal.
For RF jamming detection to work, you must select an unused zone to be used
as the RF Jam Detect zone. When the receiver detects an attempt to jam the RF
signal, the RF Jam Detect zone will be violated and the system will generate a
tamper signal. When the jamming signal is gone, the RF Jam Detect zone closes
and the system sends a tamper restore signal.
To enable RF jamming detection:
1. Enter [✱][8] [Installer’s Code].
2. Enter programming section [804].
3. Select an unused zone to be the RF Jam Detect zone. Enter the 2-digit
2. Enter programming section [804].
3. Select an unused zone to be the RF Jam Detect zone. Enter the 2-digit
number ([01] to [32]) of the RF Jam Detect zone on the keypad, then
program the serial number as [200000].
program the serial number as [200000].
3. Enter section [93]. Enter the 2-digit number of the RF Jam Detect zone
([01] to [32]) in the programming section.
4. Disable supervision for the RF Jam detect zone by turning the relevant option
off in section [82], [83], [84] or [85]. (See section 4.3 for more information.)
5. RF jamming detection is now enabled. To exit Installer programming,
press [#].
4.5 PC5132 Software Default
Returning the PC5132 programming to factory default settings is a quick way to
remove all the enrolled devices from the system and reset all the programming
in section [804].
remove all the enrolled devices from the system and reset all the programming
in section [804].
NOTE: Performing this procedure will not change any programming sections
except [804]. Resetting the control panel to factory default settings will not re-
turn the PC5132 module to factory default settings.
except [804]. Resetting the control panel to factory default settings will not re-
turn the PC5132 module to factory default settings.
To restore the PC5132 programming to the factory default settings:
1. Enter [✱][8] [Installer’s Code].
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. The software for the
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. The software for the
PC5132 will be restored to its factory default settings.
4. To continue programming the unit, exit installer’s programming by
pressing [#] and then re-enter installer’s programming by entering [✱][8]
[Installer’s Code].
[Installer’s Code].
For instructions on restoring the default programming of the control panel or any
other connected module, see your system
other connected module, see your system
Installation Manual.