Digital Security Controls Ltd. 01NB9010 User Manual
S ec ti o n 2 . 3 : C h a n g i n g O t h e r N T 9 0 10 F u n c t i o n s
4 7
Pager Format
The Communicator Format option for either telephone number can be pro-
grammed for Pager Format. If an event occurs and the Communicator Call Direc-
tion options direct the call to a telephone number with the Pager Format selected
the system will attempt to page.
The Communicator Format option for either telephone number can be pro-
grammed for Pager Format. If an event occurs and the Communicator Call Direc-
tion options direct the call to a telephone number with the Pager Format selected
the system will attempt to page.
When calling a pager extra digits will be required to make it work properly.
The following is a list of Hex digits and what function they perform:
HEX (B) - simulates the [✱] key on a Touch Tone telephone
HEX (C) - simulates the [#] key on a Touch Tone telephone, or
end of telephone number marker
HEX (D) - forces the system to search for dial tone
HEX (E)
- forces the system to pause for 2 seconds
HEX (F)
- end of telephone number marker
The system will attempt to call the pager one time. After dialing the digits in the
telephone number the system will send the account number and reporting code
followed by the [#] key (Hex [C]).
telephone number the system will send the account number and reporting code
followed by the [#] key (Hex [C]).
There is no ringback when using Pager Format. The system has no way of confirm-
ing if the pager was called successfully. A failure to communicate trouble will only
be generated once the maximum number of attempts has been reached.
ing if the pager was called successfully. A failure to communicate trouble will only
be generated once the maximum number of attempts has been reached.
NOTE:
Do not use the digit C in a reporting code when using Pager For-
mat. In most cases, the digit C will be interpreted as a [#], which will termi-
nate the page before it has finished.
nate the page before it has finished.
NOTE:
If the system detects a busy signal, it will attempt to page again.
It will make the maximum number of attempts programmed in section
[160].
[160].
NOTE:
Force dialing should be disabled when using Pager format.
NOTE:
When using Pager format, you must program two pauses (hex
digit E) at the end of the telephone number.
Communicator Format Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [360]
2.3.12 CommunicatorR
eporting
Codes
Codes
Unless you are using Automatic Contact ID or Automatic SIA formats, reporting
codes must be programmed in order for the system to report events to the central
station.
codes must be programmed in order for the system to report events to the central
station.
Reporting codes are two digits and can use hexadecimal digits A through F. To disable
a reporting code, program it as “FF” (default setting) or “00”. For a complete
description of reporting codes which can be programmed and lists of automatic Con-
tact ID and SIA format codes, please see Appendix B: Reporting Codes on page
58.
a reporting code, program it as “FF” (default setting) or “00”. For a complete
description of reporting codes which can be programmed and lists of automatic Con-
tact ID and SIA format codes, please see Appendix B: Reporting Codes on page
58.
Transmission Delay
The Transmission Delay feature is used to delay reporting of alarms. When a zone is
violated and causes an alarm, the Transmission Delay Timer will start. When the
The Transmission Delay feature is used to delay reporting of alarms. When a zone is
violated and causes an alarm, the Transmission Delay Timer will start. When the