Digital Security Controls Ltd. 09WS4985 User Manual
WS4985 One-Way Wireless Flood Detector
(English) Installation Instructions
Use this installation sheet along with the associated DSC wireless receiver and control panel installation manuals. All
instructions specified within those manuals must be observed.
instructions specified within those manuals must be observed.
The WS4985 is a one-way wireless flood detector intended for use with compatible DSC Security Systems. Multiple
WS4985 can be enrolled on and supervised by the same security panel up to the maximum supported by that panel.
WS4985 can be enrolled on and supervised by the same security panel up to the maximum supported by that panel.
The flood detector consists of a flood sensor and a wireless transmitter that are connected by a 6ft (1.82m) wire cable, see
below. This device continuously monitors for flood conditions. If flood conditions are detected, the WS4985 wirelessly
communicates this alarm condition to the control panel receiver.
below. This device continuously monitors for flood conditions. If flood conditions are detected, the WS4985 wirelessly
communicates this alarm condition to the control panel receiver.
Specifications:
Operating Humidity:
xx% RH (non-condensing) at xx°C
Operating Temperature:
-10°C to 60°C
Operating Frequency:
433MHz
Wireless Range:
xxx (show in translations only ) outdoor, line of sight
Battery:
CR2 Lithium (Panasonic/Duracell)
Battery Life:
xx years (under typical use)
Compatible with receivers:
RF5132-433/868, SCW9045/47-433/868, and RFK55XX-433/868 (keypads with receivers)
Out of Box: WS4985, Hardware pack, Installation Sheet
ACTIVATION, LOCATION and OPERATION
The WS4985 comes with the battery pre-installed. To activate it, hold the WS4985 transmitter firmly in one hand and
pull the plastic tab in the direction indicated. Then, select the locations where the transmitter and sensor will be mounted.
For detailed operation of your alarm system, refer to the Alarm System user manual.
pull the plastic tab in the direction indicated. Then, select the locations where the transmitter and sensor will be mounted.
For detailed operation of your alarm system, refer to the Alarm System user manual.
ENROLLMENT, PROGRAMMING and PLACEMENT
The one-way wireless flood detector must be enrolled on the security panel before it can transmit
system events, supervi-
sory signals, or provide the local WS4985 status (e.g., case and wall tamper switch state, battery state, and
line cut state).
STEP 1 – ENROLLING
The WS4985 can be automatically enrolled (Quick Enroll) or manually enrolled (Serial Number Programming). Perform
one of the following:
The WS4985 can be automatically enrolled (Quick Enroll) or manually enrolled (Serial Number Programming). Perform
one of the following:
QUICK ENROLL - Steps 1-4
1. Enter [*8] [Installer Code] [898] on any system keypad.
2. Place the Flood Detector near the Control panel.
3. Tamper the WS4985 by closing the circuit between the probes of the flood sensor with a screwdriver.
4. The Keypad will displays the ESN (electronic serial number). Press [*] to confirm it.
2. Place the Flood Detector near the Control panel.
3. Tamper the WS4985 by closing the circuit between the probes of the flood sensor with a screwdriver.
4. The Keypad will displays the ESN (electronic serial number). Press [*] to confirm it.
Flood Detector #
Serial Number
[xxx] #1
[xxx] #2
[xxx] #3
[xxx] #4