Digital Security Controls Ltd. 113G255SM User Manual

CAUTION: Changes or modifications not expressly approved by the Digital Security Controls could void
your authority to use this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Re-orient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/television technician for help.
The user may find the following booklet prepared by the FCC useful: ‘How to Identify and Resolve Radio/Television Interference
Problems’. This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402, Stock # 004-000-00345-4.

T

O

 

SATISFY

 FCC RF 

EXPOSURE

 

REQUIREMENTS

 

FOR

 

MOBILE

 

TRANSMITTING

 

DEVICES

, 

A

 

SEPARATION

 

DIS

-

TANCE

 

OF

 20

CM

 

OR

 

MORE

 

MUST

 

BE

 

MAINTAINED

 

BETWEEN

 

THE

 

ANTENNA

 

OF

 

THIS

 

DEVICE

 

AND

 

PERSONS

 

DURING

 

DEVICE

OPERATION

.

The prefix ‘IC:’ in front of the radio certification number signifies only that Industry Canada technical specifications were met.
Certification Number IC: 160A-3G255SM 
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Le fonctionnement est soumis aux deux condi-
tions suivantes: (1) cet appareil ne peut pas provoquer d'interférences et (2) cet appareil doit accepter toute interférence, y compris les
interferences qui peuvent causer un mauvais fonctionnement de l'appareil.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

File Name: 29007848R001_Draft_updated_by_MM_DRAFT_02 
Changes Log:
0711-3:47P - Updated 38 comments from approvals and 2 comments from safety. Emailed: mm2: DN, c/c: HA, FS, HK on 7/11 @ 4:38P.
0711-1542 - Pending comments verification from Farhad. FUp.
0716-1253 - Updated with Stephan’s comments that apply from pub request 8259, -NA manual.
0716-1253 - cw:

-to review against all comments from Aun made about pub request 8259 on 07/14 @1545 and
- to update with those that are applicable. DONE. FEW QUESTIONS (SPOTS TO WATCH) IDENTIFIED

Q-1: For Aun. Do you want in Table 4, same change in this manual as the one requested on -NA manual on Pg-6 table 5. It was in Description column. The NEW text reads:

SG-System IV (SG-DRL3IP) V2.21, and newer 

instead of original text on line-3. And line-4? Or do you want to keep it as originally left in this manual?

Q-2: SOLVED: 

UA580 

placed in the place holder instead of original diagram.

Q-3: For Stephan, Original text 

GPRS

 was replaced with 

Cellular 

(106 changes) as requested by Aun about pub rqst 8259, -NA manual on 07/14 @15:45. Is it OK?

Q-4: For Stephan, Original text 

GSM

 was replaced with 

Cellular 

(19 changes) as requested by Aun about pub rqst 8259, -NA manual on 07/14 @15:45. Is it OK?

Q-5: For Aun - Page-5 of this manual: [005] System Toggle Options. Do wee need any updates here about flashes? (Like you asked in -NA manual on 07/14 @15:45).
 
 
NOTES ARE FOR CONVENIENCE ONLY AND WILL BE REMOVED FROM FINAL VERSION.

www.dsc.com

2 9 0 0 7 8 4 8 R 0 0 1

DRAFT-02_by_MM