Digital Security Controls Ltd. 119057G User Manual

2

Read this manual carefully and have your installer instruct you on your system's operation and
on which features have been implemented in your system. All users of this system should be
fully instructed in its use. Fill out the "System Information" page with all of your zone information
and access codes, and store this manual in a safe place for future reference.
NOTE: Please consult your installer for further information regarding the false alarm reduction
features built into your system, as not all are covered in this manual.

This equipment is capable of monitoring fire detection devices such as smoke detectors and
providing a warning if a fire condition is detected. Good fire detection depends on having an
adequate number of detectors placed in appropriate locations. This equipment should be
installed in accordance with NFPA 72 (N.F.P.A., Batterymarch Park, Quincy MA 02269). Please
read the Family Escape Planning guidelines in this manual. 

This equipment is capable of monitoring carbon monoxide detectors and providing a warning if
carbon monoxide is detected. Please read the Family Escape Planning guidelines in this man-
ual and instructions that are available with the carbon monoxide detector.

To ensure that your system continues to function as intended, you must test your system weekly.
Please refer to the "Testing your System" section in this manual. If your system does not function
properly, call your installing company for service.

This system is capable of transmitting alarms, troubles, and emergency information to a central
station. If you initiate an alarm by mistake, immediately call the central station to prevent an
unnecessary response.

NOTE: The monitoring function must be enabled by the installer before it can become functional.
NOTE: This system has a communicator delay of 30 seconds. This function can be deleted, or
it can be increased up to a maximum of 45 seconds by the installer.
NOTE: Ensure that your installer verifies that your system is compatible with the Central Station
Receiver format at yearly intervals.

With normal use, the system requires minimum maintenance. Note the following points:

• Do not wash the security equipment with a wet cloth. Light dusting with a slightly moistened 

cloth should remove normal accumulations of dust.

• Replace the standby battery every 3-5 years. 

NOTE:  Do not attempt to replace the battery or open the enclosure; there is a risk of electric
shock and/or fire.

• For other system devices such as smoke detectors, motion detectors, glassbreak detectors or 

door/window contacts, consult the manufacturer’s literature for testing and maintenance 
instructions.

Your security system comprises an integrated alarm control/keypad and various sensors and
detectors. The keypad is mounted by the main entry/exit location. The system is self-contained;
electronics and standby battery are housed within the keypad unit.
NOTE:  Only the installer or service professional should have access to the system. 

The security system has several zones of area protection. Each of these zones communicates
to a single wireless sensor (motion detectors, glassbreak detectors, door contacts, etc.) or to
one or more hard-wired sensors. A sensor in alarm is indicated by messages on the LCD. 

Additional features include Automatic Inhibit (Swinger Shutdown) for Alarm; Tamper and Trouble
signals after 3 occurrences in a given set period; SMS interactive operation*; and a Programma-
ble Keypad Lockout option.
For SIA CP-01 classified installations, the swinger shutdown feature is programmed such that
one or two trips will shut down the zone. The zone will be restored after a manual reset (by