Digital Security Controls Ltd. 12GS3125 User Manual

G

G

G

G

G

PLAY button - Press to listen to the voice message again.

RECORD button - Press to start recording a new voice message.

STOP button - Press to stop replaying or recording a voice message.

GET button - Press to load the recorded voice message.

SET button - Press to send the recorded voice message to the Communicator.

ERASE button - Press this button to erase the voice message on the Communicator.

When recording a message, a progress bar indicates (in real time) the time elapsed.











To record a voice message from a touchtone telephone connected to the [LI] terminals, enable the  Local Service Mode in
the  Voice Dialler section and proceed as follows:

1. Press the 



 button;

2. Press the 



 buttons in sequence to enter record mode;

3. Enter the number of the message you wish to record (between 



 and 



);

4. After the beep, record your voice message (the maximum duration of the message is 16 seconds).

5. Press the 



 button to confirm message recording (or press the 



 button again if you wish to stop recording the message

before the full amount of time has elapsed); you will hear a boop tone.
At this moment, any previous recordings for this message will be DELETED;

6. If you need to record any other messages, repeat the procedure described in step 1.











To replay a voice message from a touchtone telephone connected to the [LI] terminals, enable the  Local Service Mode in
the  Voice Dialler section and proceed as follows:

1. Press the 



 button ;

2. Press the 



 buttons in sequence to enter replay mode;

3. Enter the number of the message you wish to replay (between 



 and 



);

4. After the beep, the message will be replayed, followed by a confirmation boop tone (press the key 



 to stop the

message playing);

5. If you need to replay any other messages, repeat the procedure described in step 1.

Through the connection (see section Connecting the device->Auxiliary connections) of MAXIASNC  tamper switch
(optional) you can detect the Communicator cover opens. To send a SMS and/or voice message to one or more telephone
numbers when the Communicator cover is removed, perform the following setup, by means of the GS3100 Series Console.
1) In the Phonebook  page, enter the telephone numbers for the tamper message.
2) In the I/O page, set the T3 terminal as Input (Type column) with NO  (Normally Open) standby status (Polarity column):

the standby status of the tamper switch is Normally Closed.

3) In the SMS dialer and/or Voice dialer page set, for the Input 3 Event, the SMS and/or the Voice message, and the

required telephone numbers.