Digital Security Controls Ltd. 16WS90029 User Manual
Chapter 3.0 Arming the System
When the exit delay has expired, the system is armed and indicated by the following conditions:
l
The Ready indicator turns off.
l
The Armed indicator stays on.
l
The keypad is silent.
Note: In Away Arming mode, manually bypassed zones are logged and communicated to the cent-
ral station.
If your system is installed in accordance with SIA CP-01 Standard for False Alarm Reduction, the
following condition applies: Violation and restoral, followed by a second violation of the entry/exit
zone before the end of the exit delay, restarts the exit delay.
Note: This function is available on the tablet and user app.
ral station.
If your system is installed in accordance with SIA CP-01 Standard for False Alarm Reduction, the
following condition applies: Violation and restoral, followed by a second violation of the entry/exit
zone before the end of the exit delay, restarts the exit delay.
Note: This function is available on the tablet and user app.
3.4 Quick Exit
If the system is armed and you must exit, use the Quick Exit function to avoid disarming and rearm-
ing the system. Using this function gives you 2 minutes to exit the premises. When the door is closed
after exiting, the remaining exit time is cancelled.
ing the system. Using this function gives you 2 minutes to exit the premises. When the door is closed
after exiting, the remaining exit time is cancelled.
3.5 Arming Errors and Exit Faults
Your security system audibly notifies you of any errors when you are attempting to arm the system
or exit the premises.
or exit the premises.
3.5.1 Arming Error
An error tone (long beep) sounds if the system is unable to arm. Arming errors occur under the fol-
lowing conditions:
lowing conditions:
l
The system is not ready to arm, i.e. sensors are open
l
The entered user code is incorrect.
l
A present trouble condition.
Ensure all sensors are secure and the system is ready to arm, then try again.
3.5.2 Audible Exit Fault
To reduce false alarms, the Audible Exit Fault notifies you of an improper exit when arming the sys-
tem. If the entry/exit door is not securely closed during the programmed exit delay, the system will
sound the alarm to indicate an improper exit.
Note: Your installer must enable this feature.
To correct and exit fault, do the following steps:
tem. If the entry/exit door is not securely closed during the programmed exit delay, the system will
sound the alarm to indicate an improper exit.
Note: Your installer must enable this feature.
To correct and exit fault, do the following steps:
1. Re-enter the premises.
2. Enter your access code to disarm the system before the entry delay timer expires
3. Ensure all sensors are secure and the system is ready to arm.
4. Repeat the Away arming procedure.
3.6 Alarm Cancel Window
There is a period of time in which you can cancel the alarm transmission. When the programmed
alarm transmission delay expires, cancelling an alarm sends a message to the central monitoring sta-
tion. When the cancellation message is successfully transmitted, the system beeps six times.
Note: Your installer can enable and configure this feature.
alarm transmission delay expires, cancelling an alarm sends a message to the central monitoring sta-
tion. When the cancellation message is successfully transmitted, the system beeps six times.
Note: Your installer can enable and configure this feature.
- 11 -