ADC Telecommunications Inc. FWM0801A User Manual
FlexWave microBTS Installation and Commissioning Guide
Page 55
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 5 - microBTS Initial Configuration
5.5
Assigning OML Link IP Address and a Static IP Address to the microBTS
Depending upon your networks requirements, a network IP address will need to be assigned to
the microBTS and each TRX. IP addresses should be obtained from your network administra-
tor. Use the following step-by-step procedure to assign a new IP address to the microBTS.
the microBTS and each TRX. IP addresses should be obtained from your network administra-
tor. Use the following step-by-step procedure to assign a new IP address to the microBTS.
1
Find the IP address of the microBTS corresponding to the micro controller.
The last MAC address listed on the exterior label will be the micro controller as shown in
Figure 5-7
.
Match this MAC address with the DHCP assigned IP address as shown in
Figure 5-12
. Open a
Web browser such as Explorer, Mozilla, etc. and using the familiar browser command:
http:// xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the IP address assigned to the micro
controller.
The following screen will appear. Refer to
Figure 5-15: FlexWave microBTS Configuration Screen
AD030908