Buffalo 09101896-0 User Manual

WZR-HP-G300NH / WZR-HP-G300NH2 User Manual

10

Chapter 1  Product Overview

This indicates the status of this unit depending on the number of blinks 
per cycle.
Note:   When the unit is first turned on or restarted, the Diag LED will blink 

for almost a minute during boot. This is normal.

2 blinks *

1

Flash ROM error

Cannot read or write to the flash memory.

3 blinks *

1

Ethernet (wired) LAN 
error

Ethernet LAN controller is malfunctioning.

4 blinks *

1

Wireless LAN error

Wireless LAN controller is malfunctioning.

5 blinks

IP address setting error

Because the network addresses of both the Internet port (WAN 
port) and the LAN port are the same, it is not possible to establish 
communication. Change the LAN side IP address of this unit.

Continuously
blinking 

*2

Updating the firmware
Saving settings
Initializing settings

Updating the firmware.
Saving the settings.
Initializing the settings.

*1 

Unplug the AC adapter from the wall socket, wait for a few seconds, and then plug it again. If the 
light still flashes, please contact technical support.

*2 

Never unplug the AC adapter while the Diag LED is blinking continuously.

Movie Engine On LED (Blue)
On: 

Movie Engine functionality is enabled.

Off:

Movie Engine functionality is disabled.

Movie Engine Off LED (Blue)
On:

Movie Engine functionality is disabled.

Off: 

Movie Engine functionality is enabled.

Movie Engine Switch
Switches the movie engine function between enabled and disabled.
On:

Movie Engine functionality is enabled.

Off:

Movie Engine functionality is disabled.