Buffalo 09102114-0 User Manual
WLI-UTX-AG300 User Manual
32
Chapter 6 - TroubleShooting
When connection to a wireless access point is not
possible
• Use a USB extension cable to bring this product closer to the wireless access point, then try
AOSS again.
• Turn the power for the wireless access point off and then on again.
• Check whether this product is correctly connected to the TV.
• If the ‘11a Only’ switch is on, turn it off.
Cannot connect to TV
• Use the supplied USB extension cable to connect.
If suddenly disconnected from the Internet
• Check that the access point is on. Have settings been changed?
• If the Security LED is blinking, perform the procedure in the Quick Setup Guide again.
Diag LED is flashing
• See the information in “Diag LED (Red)” in “Hardware Overview” of chapter 1.
Cannot access the web-based configuration interface.
• See chapter 3 for instructions to open the wireless media bridge’s configuration interface.
• Enter the correct username and password to log in to the configuration interface. The factory
defaults are “admin” (lower case) for the username and “password” (lower case) for the password .
If you changed the password, enter the new password that you set.
If you changed the password, enter the new password that you set.
• Verify that your web browser is not set to use proxies.
• Restart your wireless media bridge.