Buffalo 000000019 User Manual
42
Connect by WPS Pushbutton Method
Before starting, the print server’s connection method should be set to ‘Auto’.
1
Disconnect the Ethernet cable from the print server.
2
Disconnect the AC adapter, wait for about 10 seconds, then reconnect the AC adapter.
3
Wait for about 30 seconds. Then, press and hold the WPS button for about 5 seconds.
4
Press access point’s AOSS or WPS button to start WPS.
Note: If you are using Buffalo router, press and hold the AOSS button for at least two seconds to start WPS. This may
be different for other routers.
be different for other routers.
5
Check the LEDs on the side of the print server.
Note: If the wireless LED is blinking, the connection could not be established. Try again from step 3.