Taicom Data Systems Co Ltd AWL1000G User Manual
DC port: Insert the Power Adapter cord into the power receptacle located on the rear panel of the
Router and plug the adapter into a nearby power source. You should see the PWR (Power) LED
indicator light up and remain lit.
RESET button: The Router comes with a reset button built into the rear panel. Use this button to
restore the factory default settings. If you need to reset the Router, press the reset button for 2-3
seconds and then release it. The ADSL LED will stop blinking temporarily and then blink again
in about 15 seconds. It means the Router finish rebooting.
Router and plug the adapter into a nearby power source. You should see the PWR (Power) LED
indicator light up and remain lit.
RESET button: The Router comes with a reset button built into the rear panel. Use this button to
restore the factory default settings. If you need to reset the Router, press the reset button for 2-3
seconds and then release it. The ADSL LED will stop blinking temporarily and then blink again
in about 15 seconds. It means the Router finish rebooting.
2.3 LED Indicators
The LED Indicators read as follows:
PWR
Illuminated when the unit is powered on.
ADSL
Illuminated when the physical layer link is activated.
RXD
Illuminated when receiving data.
TXD
Illuminated when sending data.
10/100
Illuminated when the connecting speed at 100 Mbps and non-illuminated
indicates the connecting speed at 10 Mbps.
indicates the connecting speed at 10 Mbps.
LINK 1-4 Illuminated when the device is connected to LAN port(s).
Flashes when transmitting data.
W_ACT
Illuminated when the wireless functionality is activated.
Flashes when transmitting data.
Flashes when transmitting data.
W_LINK Flashes when the wireless functionality is trying to establish a wireless link.
Illuminated when the wireless client(s) is connected.
4