Michelin Americas Research Co. RV3-01-CF User Manual
MEMS Command Unit
The final user manual will contain the following text:
PRODUCT CERTIFICATION
Model: RV3-01-CF
FCC ID: FI5- RV3-01-CF
IC: 5056A-RV301CF
FCC ID: FI5- RV3-01-CF
IC: 5056A-RV301CF
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
received, including interference that may cause undesired operation.
Any modification or changes made to this device, unless explicitly approved by Michelin, will invalidate the
authorisation of this device. Operation of an unauthorised device is prohibited under Section 302 of the
Communications Act of 1934, as amended, and Subpart I of Part 2 of Chapter 47 of the Code of Federal
Regulations. This equipment must only be used with the antenna supplied. Failure to do this may void the user's
authority to operate the equipment.
authorisation of this device. Operation of an unauthorised device is prohibited under Section 302 of the
Communications Act of 1934, as amended, and Subpart I of Part 2 of Chapter 47 of the Code of Federal
Regulations. This equipment must only be used with the antenna supplied. Failure to do this may void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense.
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
received, including interference that may cause undesired operation.
This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below with
the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types
not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types
not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Procom FSP 70/433MHz +5dB gain
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Le présent émetteur radio a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne
énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
Procom FSP 70/433MHz +5dB gain
Category II licence-exempt radio apparatus
Carrier frequency 125kHz; RF field strength 54.3dBµV/m @ 3m.
La fréquence porteuse 125kHz; L’intensité de champ 54.3dBuV @ 3m.
La fréquence porteuse 125kHz; L’intensité de champ 54.3dBuV @ 3m.