TransCore 05531 User Manual
Commands
7-19
B7**
38.4 kbps
S0
one stop bit (factory default)
S1
two stop bits
P0
no parity (factory default)
P1
even parity
P2
odd parity
D0
00 ms end-of-line delay (fixed)
One space is required between each value. For example, if factory default settings are
assigned, the reader message is
assigned, the reader message is
MAIN B5 S0 P0 D0
indicating 9600 baud, one stop bit, no parity, and 0 ms end-of-line delay.
Note: The information transmitted in response to command #522 applies to data and
command mode operation only. While operating in download mode, default communi-
cations parameters are always used.
command mode operation only. While operating in download mode, default communi-
cations parameters are always used.
524 Display Appended Information Status*
Command #524 displays the information being appended to the reader transmissions.
Command #31N appends information. Append time and date are not available to the
Encompass 4/4800 Multiprotocol Reader.
Command #31N appends information. Append time and date are not available to the
Encompass 4/4800 Multiprotocol Reader.
Reader response:
IDAP T<0> D<0> X<0 to 1>
where
T0
Time not appended
T1
*
Time appended (not valid for the Encompass 4/4800
Multiprotocol Reader )
Multiprotocol Reader )
D0
Date not appended
D1
*
Date appended (not valid for the Encompass 4/4800
Multiprotocol Reader )
Multiprotocol Reader )
X0
Auxiliary information not appended (factory default)
X1
Auxiliary information appended